CLV REPAIR 700
Single-Component Cementitious Repair and Smoothing Mortar, Polymer/Fibre-Reinforced, for Smooth Concrete Finishes
CLV REPAIR 700 is a single-component, cementitious repair mortar with polymer and fibre additives. It provides a smooth finish on concrete surfaces and is used for surface smoothing. It is classified as EN 1504-3/R2.
• Mixed with water; easy to apply.
• Provides high adhesion; bonds strongly to concrete surfaces.
• Crack-free application; easy to use on large surfaces.
• Non-sagging owing to its thixotropic nature.
• Waterproof.
• Resistant to freeze–thaw cycles.

FEATURES AND BENEFITS
-
• Mixed with water; easy to apply.
• Provides high adhesion; bonds strongly to concrete surfaces.
• Crack-free application; easy to use on large surfaces.
• Non-sagging owing to its thixotropic nature.
• Waterproof.
• Resistant to freeze–thaw cycles.
FIELDS OF APPLICATION
-
• Concrete surfaces prior to epoxy waterproofing
• Industrial floors beneath epoxy floor coatings
• Creating a sound, impermeable layer on bare concrete
• Surface preparation prior to coating on slabs subject to light/medium traffic loads
• Achieving a smooth, impermeable surface on concrete prior to painting
• For levelling areas repaired with structural repair mortar
• Repairing surface defects in concrete elements
Product Details
1.72 kg/m² of powder product for 1 mm thickness.
25 kg polyethylene-lined kraft paper bag
12 months from the date of production. Store in the unopened original packaging in a cool, dry place, protected from frost. For short-term storage, stack no more than 3 pallets on top of each other and dispatch on a first-in, first-out basis. For long-term storage, pallets must not be stacked.
| PROPERTY | TEST METHOD | VALUE |
|---|---|---|
| Chemical Base | Clever Lab. | Mineral fillers and polymer-modified special cement |
| Shelf Life | Clever Lab. | 12 months |
| Consumption | Clever Lab. | 1.72 kg/m² per 1 mm |
| Appearance / Colour | Clever Lab. | Grey |
| Density | Clever Lab. | 2.05 kg/L |
| Packaging | Clever Lab. | 20 kg polyethylene-lined kraft paper bag |
| Curing Time | Clever Lab. | 28 days |
Application
• SURFACE PREPARATION
Substrates must be sound, clean, dry and free from dirt, oil, grease, etc. and loose particles. Depending on their type, substrates must be mechanically cleaned and/or primed. Abrasive blasting must be carried out if necessary.
• MIXING
Add 4.75 L of water to the 25 kg pack of CLV REPAIR 700 and mix for 4 minutes with a 400–600 rpm mixer until a homogeneous, lump-free mix is obtained. Allow to stand for approx. 4 minutes and remix for 30 seconds; the material is then ready for use.
• APPLICATION
Check that the substrate moisture, relative humidity and dew point conditions are suitable. • Cover damaged areas with tape or suitable material. • Test suitability on other substrates. • Refer to the Technical Data Sheet for waiting times and top coats.
The repair mortar must be applied within 45 minutes at +20 °C. At +30 °C this time is 20–25 minutes. Working and reaction times of cementitious systems are affected by ambient and substrate temperature and by relative humidity. Low temperatures slow down hydration, which extends the pot life and working time. High temperatures accelerate hydration, and the times stated above are shortened accordingly. For the material to complete setting, the ambient and substrate temperatures must not fall below the minimum permitted temperature. For exterior applications, the surface must be protected from sun, wind, rain and frost for the first 24 hours after application.