ClvFloor TC 490
Polyurethane-Based, UV-Resistant, Coloured, Elastic, Matt Two-Component Top Coat
ClvFloor TC 490 is a matt polyurethane protective top coat for floors with high abrasion and chemical resistance.
• Good abrasion and chemical resistance • Resistant to UV and weathering • Low viscosity • Odourless • Long-lasting • Elastic • Excellent adhesion to non-absorbent substrates

FEATURES AND BENEFITS
-
• Good abrasion and chemical resistance • Resistant to UV and weathering • Low viscosity • Odourless • Long-lasting • Elastic • Excellent adhesion to non-absorbent substrates
FIELDS OF APPLICATION
-
ClvFloor TC 490 can be applied as the top coat of floor coating systems.
Product Details
0.10–0.20 kg/m²
Component A (liquid): 16.00 kg metal pail Component B (liquid): 4.64 kg metal pail A+B kit: 20.64 kg kit
Refer to the 'Expiry Date' label on the pack for the shelf life under proper storage conditions. Storage conditions: store correctly in the original, unopened and undamaged packaging in a dry place between +5 °C and +30 °C. Protect from direct sunlight
| PROPERTY | TEST METHOD | VALUE |
|---|---|---|
| Chemical Base | Clever Lab. | Polyurethane |
| Mixing Ratio | Clever Lab. | 72:28 (A:B, by weight) |
| Consumption | Clever Lab. | 0.10–0.20 kg/m² |
| Appearance / Colour | Clever Lab. | Wide range of colours |
| Density | Clever Lab. | Comp. A+B: ~1.31 g/cm³ |
| Application Temperature | Clever Lab. | +10 °C to +30 °C |
| Ambient Temperature | Clever Lab. | +10 °C to +30 °C |
| Packaging | Clever Lab. | A: 16.00 kg B: 4.64 kg Kit: 20.64 kg |
| Working Time | Clever Lab. | 35 min / +20 °C |
| Curing Time | Clever Lab. | +23 °C / 50% RH: Light foot traffic: 48 h Full cure: 7 days |
Application
• SURFACE PREPARATION
The substrate must be free from dust, dirt, oil and other substances that would prevent adhesion. Application must take place within the overcoating time of the coating system. When applying over old coatings, consult our Technical Department regarding the application method.
• MIXING
Mix with a mechanical mixer at low speed (300 rpm) for at least 3 minutes. Scrape down the material on the sides and ensure that it is thoroughly mixed with the material at the bottom of the mixing container. Once a mix of homogeneous consistency has been prepared from components A and B, transfer it to a clean container and mix again for 1 minute.
• APPLICATION
Apply evenly to the surface with a short-pile roller. Before application, check that the relative humidity and dew point conditions are suitable.
• Before mixing, the temperature of components A and B must be approx. +15 °C to +25 °C. Transfer the entire contents of components A and B into a clean bucket.
• The surface must not come into direct contact with water for at least 24 hours after application (23 °C / 50%).
• Application must take place within the overcoating time of the coating system.