ClvSeal PLUG
Cementitious, Rapid-Setting Water-Stop Plugging Mortar
ClvSeal PLUG is a cementitious, rapid-setting plugging mortar used to stop water leaks.
• Can be applied either dry or mixed with sufficient water to form a mortar.
• Stops water leaks very quickly.
• Ready to use.
• Chloride-free; does not damage reinforcement.
• Waterproofing materials can be applied over it after 15–20 minutes.

FEATURES AND BENEFITS
-
• Can be applied either dry or mixed with sufficient water to form a mortar.
• Stops water leaks very quickly.
• Ready to use.
• Chloride-free; does not damage reinforcement.
• Waterproofing materials can be applied over it after 15–20 minutes.
FIELDS OF APPLICATION
-
• Lift shafts
• Basements and foundations
• Interior and exterior reinforced concrete walls of water reservoirs and tanks
• Reservoirs, drainage systems, tunnels
• Underground garages and storage areas
Product Details
5 kg plastic pail; grey in colour.
12 months from date of production. Storage Conditions Store correctly in the original, unopened and undamaged packaging in dry conditions at between +5 °C and +30 °C.
| PROPERTY | TEST METHOD | VALUE |
|---|---|---|
| Chemical Base | Clever Lab. | Cement-based powder |
| Shelf Life | Clever Lab. | 12 months |
| Appearance / Colour | Clever Lab. | Powder, grey |
| Solids Content | Clever Lab. | 100% |
| Application Temperature | Clever Lab. | +5 °C to +35 °C |
Application
• SURFACE PREPARATION
The substrate must be sound, dry, load-bearing, clean and dust-free. Oil, grease, rust, tar, paint and curing residues that reduce adhesion must be completely removed. Existing cracks and voids must be opened to a width and depth of at least 20 mm with perpendicular edges. V-shaped cross-sections must be avoided, and no sharp corners or weak details must be left.
• APPLICATION
Mixing:
Mix by hand, wearing gloves, in a clean container with sufficient water, only as much material as can be applied within 60 seconds. Mixing time must not exceed 30 seconds. In cold weather, lukewarm/warm water must be used; no aggregate, chemicals or foreign matter must be added to the mix.
ClvSeal PLUG: 5 kg Mixing water quantity: 1.20–1.40 L 1 kg of ClvSeal PLUG is mixed with 0.24–0.28 litres of clean water. (Ratios vary according to ambient and weather conditions.) The leaking crack must be opened to a width and depth of at least 20 mm until sound substrate is reached. Mix with an appropriate amount of water and form into a cone. When the reaction starts, apply the material to the leak point in a single movement and hold it under constant pressure for at least 60 seconds. Release the pressure slowly after hardening. For voids that cannot be sealed in a single application, repeat the process from the edges towards the centre. Remove excess material immediately after application.